Using industrial casters increase production capacity - the leg parameters

Floor in the leg is connection of industrial casters and wheels are very important parts, can through the leg connects the two to a piece of to form a complete industrial casters, otherwise can only call it the wheel; And the leg as important fittings of industrial casters, so the problems such as the size of the leg is also more attention, because good support legs is good for our production process to reduce production time, to reduce the risk of bad product produce, improve production efficiency, so as a commonly used spare parts support legs should also be careful in production. The use of industrial caster wheel is a big business, of course, if we don't really care, can be replaced with different castor. , but it will still appear some bad influence, if we know enough about it to better use it, the different industrial casters, support legs carrying the weight of the different applications in different environment. The rational use of the leg is to extend the service life of industrial casters and the best way to reduce itself costs. 1, pay attention to the product support leg bending direction, do not play against; 2, R the leg blanking to 90 ° vertically, not tilt; 3, bolt hole in the center of the leg piece, left and right deviation less than 0. 5毫米; 4, attention to the quality of the plate ( Rusty spot, scratch, bump marks, etc. ) ; 5, pay attention to the bolt hole size, size is too small not interspersed with bolts; 6, the size of the leg height conforms to normal size, not too high or too low; 7, plate thickness corresponding to the corresponding series of products, such as MH2000 5 series. 5毫米; 8, pay attention to the brake hole position, pay attention to when strong brake hole activity gap not too big; 9, cut sheet width as the normal size, normal than standard 0. 5 mm range fluctuations; 10, pay attention to a trademark clarity, do not put the upside down, from when the position of using; 11, pay attention to the bolt hole, shear and die cutting burr size, do not affect the appearance and performance; How to clearly understand the leg usage more than eleven o 'clock is very important, it can improve the performance of the leg, the use of the extended industrial casters cycle; Industrial castor industry sales increasing competition on the market at present, we are against the market pressure, many businesses would have to cut corners, but this does not solve the fundamental problem, how to make the industrial casters more walk more good, do a good job in itself product quality is the foundation, the basic problem.