Stainless steel caster operation matters needing attention

Stainless steel caster operation notice: 1, the light to take light put, avoid midway knock against damage; 2, according to the load of castor, not beyond the maximum load; 3, according to the product usage instruction manual avoid using more damage in high speed; 4, to avoid collision in the process of operation, guarantee the normal work of the between the wheel and equipment; Stainless steel castor safety carrying note: 1, the trundle operation environment is a special case, not only to choose corresponding castor, should also be equipped with reasonable design structure increase impact resistant ability. 2, the most common installation mode into four wheel casters, in place of casters under the impact of small, also is the occasion of the ground is in good condition, can be in or equipment moving shipment, according to the four casters under one hundred and thirty percent of the total weight. 3, where the ground environment is poorer, more is to require three castor full weight, the use of a castor hung up, according to the situation three wheel bearing capacity calculation, and the maximum limit of not more than three wheels, or it will affect normal operation of castor. Stainless steel caster wheel can be called a directional casters and universal casters. Directional casters with single wheel on a support, can only move along a straight line. Universal caster wheel is made up of 360 degrees to stent with single wheel, can freely move in any direction. Installation height: refers to from the ground to the vertical distance between equipment installation position, the installation of the castor height refers to remote the largest vertical distance and castor base plate and the wheel. Stand to center distance: refers to the vertical line to the center of the wheel core center rivet horizontal distance. Turning radius: refers to the center of rivet vertical line to the outside of the tire on the edge of the horizontal distance, proper spacing of the caster wheel can be turned 360 degrees. The turning radius is reasonable or not directly affects the service life of the castor. To: hard, narrow wheel than soft, wide wheels turn more easily. Rotate wheel radius is one of the important parameters, short turning radius increases to the difficulty, too much will cause the wheels wobble and shorten the life. Driving flexibility: factors affecting driving castor flexibility with stents of the structure and the selection of steel, the size of the wheel, wheel type, bearing, wheel driving the greater flexibility, the better, hard on the smooth ground, narrow wheel than flat soft wheels and effort, but on the uneven ground soft wheels and effort, but on the uneven ground soft wheels can better protect equipment and avoid vibration. Driving load: castor moving load bearing capacity is also called dynamic load, dynamic load of the castor is different due to the test in a different way of the factory, the material of the wheel will have different and different, the key is to support the structure and quality can impact and shock resistance. Impact load: when the equipment has fundamental impact or vibration castor instantaneous load bearing capacity. Static load: castor can bear the weight of the under stationary state. Static load generally should exercise load ( Dynamic load) 5 ~ 6 times, static load should be at least 2 times the impact load.